Differenze

Queste sono le differenze tra la revisione selezionata e la versione attuale della pagina.

Link a questa pagina di confronto

Entrambe le parti precedenti la revisione Revisione precedente
Prossima revisione
Revisione precedente
Ultima revisione Entrambe le parti successive la revisione
notes:papers.notes [13/05/2018 20:54]
alez [Pinouts & Wirings]
notes:papers.notes [22/12/2018 23:49]
alez [METEOR START-UNI 1ST052642 barcode scanner wiring]
Linea 111: Linea 111:
 Note: +5Vcc line interrupted by external adaptor plug: if plug is inserted, ps/2 vcc is disconnected and external + goes to scanner Note: +5Vcc line interrupted by external adaptor plug: if plug is inserted, ps/2 vcc is disconnected and external + goes to scanner
  
 +=== METEOR START-UNI 1ST052642 barcode scanner wiring ===
 +
 +The handheld scanner presents a cable with a DB9 female on its ending. It has an adapter from DB9 Male to 2 x PS/2 (DIN) Male & Female.
 +Inside the handheld scanner, the cable attaches to K2 on an aux pcb with a 232 transceiver and the pushbutton switch. K1 on this pcb goes to the real barcode scanner PCB assy. The following table represents wiring, between brackets wiring through the RS232 transceiver.
 +
 +^ PS2 male ^ PS2 female ^ DB9 (scanner) ^ wire colour ^ K2 ^ K1 ^ note ^
 +|    4     ​| ​    ​4 ​     |       ​9 ​      ​| ​  ​black ​    | 1 | 1  | VCC +5V |
 +|    3     ​| ​    ​3 ​     |       ​7 ​      ​| ​   purple ​  | 2 | 2+3  | GND |
 +|          |            |               ​| ​            ​| ​  | 4  | switch to gnd |
 +|          |     ​5 ​     |       ​4 ​      ​| ​  ​green ​    | 5 | 5  | ps2 clock out |
 +|          |     ​1 ​     |       ​8 ​      ​| ​   grey     | 6 | 6  | ps2 data in |
 +|          |            |       ​3 ​      ​| ​  ​yellow ​   | 8 | (7)  | rs232 RX (from host) |
 +|          |            |       ​5 ​      ​| ​  ​blue ​     | 7 | (8)  | rs232 TX (to host) |
 +|    1     ​| ​           |       ​1 ​      ​| ​ brown      | 3 | 9  | ps2 data out |
 +|    5     ​| ​           |       ​2 ​      ​| ​   red      | 4 | 10  | ps2 clock in |
 +
 +Not mentioned pins are Not Connected. The aux pcb also has a jumper and a 7805 footprint for +12V supply from the same K2 pin 1. The jumper & 7805 footprint are between K2 pin 1 and K1 pin 1.
 === Urmet domus power supply and peripherals === === Urmet domus power supply and peripherals ===
  
Linea 238: Linea 255:
 used for intercoms, etc.. used for intercoms, etc..
 4 pin XLR : 1. MIC GND - 2. MIC SIGNAL - 3. EARPHONES GND - 4. EARPHONES SIGNAL 4 pin XLR : 1. MIC GND - 2. MIC SIGNAL - 3. EARPHONES GND - 4. EARPHONES SIGNAL
 +
 +
 +===== Cinema-tech =====
 +
 +  * **Dolby Sorround** = fittizio, parte da una traccia stereo e ricrea il rear con un po di delay
 +  * **Dolby Spectral Recording** (per il cinema) e **Dolby Pro Logic** (per l'home teather) = appare il canale centrale e (opzionale) il canale LFE (low frequency effects)
 +  * **Dolby Digital** = codifica AC3 multicanale
 +  * **DTS** = più raffinato rispetto al Dolby Digital
 +
 +
 +**CINEMASCOPE** da pellicola [-] apre a schermo 221:100 [ -- ]
Navigazione

Table of contents

Contact

For any info you can write to:
Per qualunque info potete scrivere a:
info[at]maetech[dot]it

Ads

Stampa/Esporta
QR Code
QR Code notes:papers.notes (generated for current page)